This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to set ITM Trace Buffer Size on STM32H7

Fanta over 5 years ago

Hello,

I'm trying to debug a continuous ADC signal. Unfortunately every few µs the Trace buffer overflows. This results in Steps inside the Logic analyzer. Is there a way to set it to a bigger size?

I'm using Keil with a STM32H7 Nucleo board with the ST-Link v2 debugger.

Thanks
Regards Fanta

Example:

Parents

0 Sankalp Agarwal over 5 years ago

Which debug adapter are you using ?

If it is ULINK2 then below link should be helpful:
http://www.keil.com/support/man/docs/ulink2/ulink2_trace_status.htm

If it is ULINK Pro then below link should help:
http://www.keil.com/support/man/docs/ulinkpro/ulinkpro_trace_status.htm
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Sankalp Agarwal over 5 years ago

Which debug adapter are you using ?

If it is ULINK2 then below link should be helpful:
http://www.keil.com/support/man/docs/ulink2/ulink2_trace_status.htm

If it is ULINK Pro then below link should help:
http://www.keil.com/support/man/docs/ulinkpro/ulinkpro_trace_status.htm
Cancel
Vote up 0 Vote down

Cancel

Children

0 Westonsupermare Pier over 5 years ago in reply to Sankalp Agarwal

Says ST-LINK/V2
Cancel
Vote up 0 Vote down

Cancel