Options

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

uVision 5.29.0.0 WIN 10 PC new project. No device in “Select a device for target1” form's left box. My Device is ATSAME54P20A and is displayed in left column of Pack Installer. All packs/examples “up to date”.

StJoe over 5 years ago

I have searched for and have tried many suggestions but nothing seems to solve the

problem. I am missing something or make the same mistake over and over. Please help.

0 rkopsch over 5 years ago

I just successfully completed a ATSAME54P20A -selection with MDK 5.29 after installing Atmel::SAME54_DFP 1.1.134.

http://www2.keil.com/mdk5/packinstaller/

Next I generated a project and the build was successful:

Fyi - Setup Keil MDK:

https://www.youtube.com/watch?v=d_O2tu5CMbQ&feature=emb_logo
Cancel
Vote up 0 Vote down

Cancel
0 StJoe over 5 years ago in reply to rkopsch

Thank you very much. I uninstalled Keil uVision 5, removed everything Keil from my hard disk, Installed uVision 5 again, created new project per your reply and WALA SUCCESS FINALLY. I assume I made some blunder with previous installation followed with more blunders. Again thanks.
Cancel
Vote up 0 Vote down

Cancel
0 Andy Neil over 5 years ago in reply to StJoe
Cancel
Vote up 0 Vote down

Cancel