Hello !
I am working on bootloader application using RTX on mdk 5.
The bootloader load the user application using Ethernet communication and proceed to the jump after a reset.
When i use an simple blinky example and modify the BCA, the jump WORKS WELL !
BUT If I use an RTX application, the jump don't works.
I used the bootloader's vendor (without RTX) the jump to my RTX application works..
I suspect that RTX application erased some thing at initialization
Some one already seen that before
Board used : FRDM K64F
IDE : mdk 5
You seem to be in Handler Mode. You need to be in Thread Mode.
MSP, Prividged, Thread Mode.
__set_control(0x00000000); est the privileged mode, i dis but drill in handler mode
Sorry. You are in a Hard Fault so obviously you are in Handler Mode. Maybe see what state you are in just before the jump to the application.