I have seen some confusing information posted regarding "ADuC debug" using the Accutron "Spear" and "Uspear" products.
Quick history to clarify:
======= 1. ACE ======= # the first single pin debugger from accutron. # connection to PC via the serial port. # Accutron Debugger: ACE # no longer sold. = = = = ======== 2. Spear ======== # The ACE was replaced by the "spear". # Added Support for single cycle devices ADuC84x family. # Low Cost. # connected again to the PC via serial port. # No longer sold due to European Lead free regulations. # uVision Driver: www.accutron.com/.../Keil-spear.zip
# Accutron Debugger: Aspire V1.x.x download www.accutron.com/.../Aspire_V1_0_7.zip = = = = ========= 3. USpear ========= # "Spear" was replaced by the current debugger "USpear", see " href= "www.accutron.com/.../USPEAR_Keil.zip">www.accutron.com/.../USPEAR_Keil.zip
# Accutron Debugger: Aspire V2.x.x download www.accutron.com/.../Aspire_V2_0_3.zip = = = =
Hello,
This Post was not a question but a comment, and refers to the now closed thread:
http://www.keil.com/forum/docs/thread10090.asp
I would have posted these comment there, but am unable to post to that thread.
when beginning to use these tools with uVision i came across the above thread, I found this thread caused me a lot of confusion an impaired my work with uVision.
I wish to pass on my experience of the tools under uVision in an effort that users would not be lead down the same path, of mismatching drivers and hardware ...
thank you for your comments.
Jed...
...if you'd explained that in the first place - including the link to the old thread!
Oh well, now we know!
:-)
sorry about the confusion caused