This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Segmentation faut error in armcc.exe

Hi All:
I was using uVision 3 with the RealView 3 'C' compiler without problem for a while... Suddenly, I got an error from the compiler:

** Segmentation fault

and I got an unhandled win32 exception from the armcc.exe program.

I desintalled and re-installed the programs again, but the error still there...
It would be a hardware memory error?

Thanks;
Gus

Parents Reply Children
  • You might try going back to a prior, known good (i.e., builds without errors or warnings) version of your source code and trying again. If the problem does not go away, that would seem to point to a problem with the tools. However, if the problem goes away, then you can try putting the changes back, one piece at a time till the problem shows up again. Then you can try to figure out if the fault lies with your code or the tools. If you're sure it's the tools, contact KEIL tech support, and provide them a test case to show the problem you're having. They're pretty good at responding to tech support requests. Giving them a (small as possible) test case makes it much, much easier for them to figure out what's wrong.