• State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 22 subscribers
  • Views 2546 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Code Execution using toolbox button

neo neo

Dear All,

I am using microvision 2 and c8051F12x.

I want to execute a function stored in the code memory using a toolbox button. I have created a toolbox button which loads the PC with the address of the particular function.That is working fine and if I wan to execute the function, I have to press F5 or F10 or F11 until the end of the function.
But, is there any way to execute the function in code space by just clicking the toolbox button?

Thanks in advance,
- Neo

Parents
  • 0 in reply to Andy Neil

    Just by the way, note that the toolset for this should be "Cx51 & 8051 Development Tools" - not "C251"

    Sorry, it was by accidental

    Thankyou both!

    And Keil,
    I want to know the other available commands similar to "G". Where can I get those command set?

    Thanks again.
    - Neo

Reply
  • 0 in reply to Andy Neil

    Just by the way, note that the toolset for this should be "Cx51 & 8051 Development Tools" - not "C251"

    Sorry, it was by accidental

    Thankyou both!

    And Keil,
    I want to know the other available commands similar to "G". Where can I get those command set?

    Thanks again.
    - Neo

Children