• State Not Answered
  • Locked Locked
  • Replies 6 replies
  • Subscribers 20 subscribers
  • Views 6366 views
  • Users 0 members are here
Options
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

STM32F103 + PWM+ DMA +HAL problem?

Charles Bewer

I have STM32F103 working on 8MHz. Use new ST HAL Driver (STM32CubeMX) + MDK-ARM v5.17?
If I Init PWM on Ch1 Tim3

void MX_TIM3_Init(void)
{
  TIM_ClockConfigTypeDef sClockSourceConfig;
  TIM_MasterConfigTypeDef sMasterConfig;
  TIM_OC_InitTypeDef sConfigOC;

  htim3.Instance = TIM3;
  htim3.Init.Prescaler = 0;
  htim3.Init.CounterMode = TIM_COUNTERMODE_UP;
  htim3.Init.Period = 9;
  htim3.Init.ClockDivision = TIM_CLOCKDIVISION_DIV1;
  HAL_TIM_Base_Init(&htim3);

  sClockSourceConfig.ClockSource = TIM_CLOCKSOURCE_INTERNAL;
  HAL_TIM_ConfigClockSource(&htim3, &sClockSourceConfig);

  HAL_TIM_PWM_Init(&htim3);

  sMasterConfig.MasterOutputTrigger = TIM_TRGO_RESET;
  sMasterConfig.MasterSlaveMode = TIM_MASTERSLAVEMODE_DISABLE;
  HAL_TIMEx_MasterConfigSynchronization(&htim3, &sMasterConfig);

  sConfigOC.OCMode = TIM_OCMODE_PWM1;
  sConfigOC.Pulse = 1;
  sConfigOC.OCPolarity = TIM_OCPOLARITY_HIGH;
  sConfigOC.OCFastMode = TIM_OCFAST_DISABLE;
  HAL_TIM_PWM_ConfigChannel(&htim3, &sConfigOC, TIM_CHANNEL_1);
}
...
// Start PWM
HAL_TIM_PWM_Start_IT(&htim3, TIM_CHANNEL_1);

all working OK and output generate 125ns pulse on 800kHz (1.25us)
If replace Start_IT with DMA version

uint32_t pData[1]={6};
HAL_TIM_PWM_Start_DMA(&htim3, TIM_CHANNEL_1,pData,1);

all working OK and output generate 700ns pulse on 800kHz (1.25us),but if use

uint32_t pData[16]={3,3,3,3,3,3,3,3,0,0,0,0,0,0,0,0};
HAL_TIM_PWM_Start_DMA(&htim3, TIM_CHANNEL_1,pData,16);

this genreate 375ns its OK but frequency is 400kHz (2,5us)
If I trace and look on reg CCR1 I see
3,0,3,0,3,0,3,0,3,0,3,0,3,0,3,0
What's wrong, what's the problem?
Why is inserted 0 between 3?

0