This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

STM32F3 fail to download to flash

Hi, I'm new with Keil software so in advance please be patient with me.

After all software installation I decided to test a demo code in my STM32f3discovery board, but... at the moment on clicking Flash-> Download, it appears a screen saying: "No target connected" followed by another screen displaying: "Error: Flash Download failed - Target DLL has been cancelled"

Any ideas on how to fix this issue?

Note: I already went into configuring flash tools and selecting ST-Link Debugger on Utilities and Debug tab, but no results still.

Thanks for your time

Parents
  • Please,

    could you be more precise... i have the same problem. i have not jumper on the 4 pins where is written st-link discovery. But i have tried to put it covering the first 2 on the right then the first 2 on the left, and more all four, finally just the 2 in the middle... I still have the problem

    Thank you for your time

    Cordially

    Antonio

Reply
  • Please,

    could you be more precise... i have the same problem. i have not jumper on the 4 pins where is written st-link discovery. But i have tried to put it covering the first 2 on the right then the first 2 on the left, and more all four, finally just the 2 in the middle... I still have the problem

    Thank you for your time

    Cordially

    Antonio

Children
No data