Hi, I'm new with Keil software so in advance please be patient with me.
After all software installation I decided to test a demo code in my STM32f3discovery board, but... at the moment on clicking Flash-> Download, it appears a screen saying: "No target connected" followed by another screen displaying: "Error: Flash Download failed - Target DLL has been cancelled"
Any ideas on how to fix this issue?
Note: I already went into configuring flash tools and selecting ST-Link Debugger on Utilities and Debug tab, but no results still.
Thanks for your time
Hi, I finally figure it out! I was missing the little plastic "bridge"? that is supposed to go on the board where it says ST-LINK / DISCOVERY, now everything is working properly!
Thanks for your response.
Please,
could you be more precise... i have the same problem. i have not jumper on the 4 pins where is written st-link discovery. But i have tried to put it covering the first 2 on the right then the first 2 on the left, and more all four, finally just the 2 in the middle... I still have the problem
Thank you for your time
Cordially
Antonio