• State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 22 subscribers
  • Views 1597 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

(RTX,STM32) How to use the serial port?

L akeer

Hi everybody,I'm learning to use RTX RTOS,but I don't know how to use the USART of STM32 in RTX.
Do you have this example? Thank you very much!

Parents
  • 0

    But do you know how to use the USART without RTX?

    Because in that case it's just a question of signalling a producer thread if the USART code is running low on data to send. And signal a consumer thread if you have received data - either by sending the data directly to the thread or by storing in a buffer and setting an event that data is available. So same-same as for other USART + OS combinations.

Reply
  • 0

    But do you know how to use the USART without RTX?

    Because in that case it's just a question of signalling a producer thread if the USART code is running low on data to send. And signal a consumer thread if you have received data - either by sending the data directly to the thread or by storing in a buffer and setting an event that data is available. So same-same as for other USART + OS combinations.

Children
No data