Hello All,
I have been working with the LM3S8962 development board, TI, cortex M3. I am attempting to use the debugger to trace .elf files. (Is this possible with KEIL ?)
Initially, I used the JTAG interface suppoted by the ULINK PRO hardware device. I had plugged the debugger module into the DEV board. I wanted test the debugger with a test program. After having set up the hardware by powering it, the keil software throws me an error "Firmware outdated!".
I have also downloaded the keil update software (MDK420.exe), I obtained from the website.
However, when I try to install it, I face troubles.
"Cannot create destination file 'c:\Users\XXXX\AppData\Local\Temp\KS1229.tmp\´ System error code: Invalid window handle. Retry ?
How to I proceed with the installation and get the debugger to work ?
Please give me your sugestions and help.
Awaiting your response.
Raman.
I'm an end user like yourself - this is an end-user forum and not the official Keil helpdesk - so I don't have any absolute answers.
I belive I was queried if I wanted to upgrade my Ulink when I switched to a newer version uVision that found the Ulink firmware to be old.
Oh. Thanks a ton. :)
I will check the process again.
Also, where can I find the official ARM help desk ? (Is there any ?)
Thanks again.
Raman
There's a link marked 'Contact' at bottom-left of the page - the clue is in the name...