hi i work on n version programming over the controller area network and need at least 4 can transceiver for implementing that(1 for voter, 3 for sending the data) because i am going to simulate the function, i should have access to every 4 transceiver at the same time. can any one say me how i can do that? and which micro controller(s) must be used?
Do you run them all on the same PC? One PC will do very well. I admit that it can be an advantage to use multiple monitors (on one PC) to observe which reached a breakpoint f1rst, that,however is convenience, not requirement.
If so, does that mean it needs to be a "high-spec" PC? I do not know if Microsoft has got it fixed, but there were some real problems with USB expanders running this reliably. I have extra USB ports installed.
I, actually, was totally flabbergasted when I found that the SILabs programmers (who did not invent the hot water) had made this possible.
Erik