• State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 22 subscribers
  • Views 1114 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

C164ci Simulation - Show CAPCOM pin toggling in Logig Analyzer

Sammy el Baradie

Hi,

is it possible for the C164ci target in simulation mode to make the pin toggling of the CAPCOM output visible inside the Logic Analyzer (PK-166)?

I am using the CAPCOM6 in Edge Aligned mode, cnfigured for PWM usage. I would like to debug the output signalCOUT60 (P1L.1) and COUT61 (P1L.3) using the Logic Analyzer.

/* PWM0 and PWM1 signal frequency configuration */
D_PWM1 = 1;
D_PWM2 = 1;
/* Configuration of the PWM outputs */
CC6MSEL = 0x0022;
/* 5V -> 10bits */
CTCON = 0x001C;
/* 10230 = 100% full scale */
T12P = 10230;
T12OF = 0;

Thank you in advance for any hints or experiences,
Sammy

Parents
  • 0

    Hi Chris,

    thank you very very much for your help :-))
    I can now simulate the output of the CAPCOM6 within the Logic Analyzer, using exactly your code. :-))
    For viewing pin toggling within the Logic Analyzer I need to setup the VTREGs of the ports PORT1L.1 and PORT1L.3.

    Great it works,
    Sammy

Reply
  • 0

    Hi Chris,

    thank you very very much for your help :-))
    I can now simulate the output of the CAPCOM6 within the Logic Analyzer, using exactly your code. :-))
    For viewing pin toggling within the Logic Analyzer I need to setup the VTREGs of the ports PORT1L.1 and PORT1L.3.

    Great it works,
    Sammy

Children
No data