We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hi everyone. I have the Atmel AT91SAM7X256-EK board, uVision3 and ULINK . I have successfully installed the ULINK on my machine, however, every time I try to program the flash through ULINK, I get the following error: "Error: Flash download failed - Target DLL has been cancelled". When I try to run in debug mode, I get a similar error. I can't seem to figure out what is causing the problem.
Can anyone suggest a solution?
Thanks
Set the ULINK communication frequency to 100Khz. It is 1Mhz by default.
Regards
Suvidh
Thanks. 100KHz didn't actually work, I had to drop down the speed to 10KHz - but it worked.
Thank you very much.
Vartan