We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Is it ok that my MCB2300 doesn't run after I've unpluged the ULINK2 box from it? Because of eval.version?
If it is so, could somebody please explain it in steps why it happens and what is going on after I press "Load" buttom in microvision software. Or one can find a documentation on it. Actually I expect the code is in flash memory.
I tried it with ex. "Blinky".
Thanks Serg
or checksum?
The following discussion seems relevant to this one too
http://www.keil.com/forum/docs/thread10121.asp
Keeping the JTAG connector of the ULINK2 connected and removing the power to the ULINK2 does stops the working of the evaluation board.
You need to unplug the jtag connector / ULINK from the board for proper working.
Regards
Suvidh