This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

fx2 serial mode0

Hi,
i am working on CY7C68013 chip.I am trying to implement SPI using mode0.1Mhz clock is generating,but data is not generating.(CLOCKOUT=24Mhz.I used SM2=0 i.e 24 mhz/12Mhz)I have to get 2 Mhz clock .Below i have attached piece of code which i tried.

main()
{

PORTECFG=0x08; //Turn on uart pin rxd0out
SCON0 = 0x13; //Mode 0, baud 24/12, enable receive,TI=1;RI=1;
// CKCON &= 0xF8; //Set stretch 0*/

while(1)
{ TI = FALSE;
SBUF0='B';//spi_Data;
// for(i=0;i<1000;i++);
while(!TI);
}

}

please help me to solve this issue.

Regards,
smitha

Parents
  • Hi,
    i am working on CY7C68013 chip.I am trying to implement SPI using mode0.1Mhz clock is generating,but data is not generating.(CLOCKOUT=24Mhz.I used SM2=0 i.e 24 mhz/12Mhz)I have to get 2 Mhz clock .Below i have attached piece of code which i tried.

    main()
    {
    
    PORTECFG=0x08; //Turn on uart pin rxd0out
    SCON0 = 0x13; //Mode 0, baud 24/12, enable receive,TI=1;RI=1;
    // CKCON &= 0xF8; //Set stretch 0*/
    
    while(1)
    { TI = FALSE;
    SBUF0='B';//spi_Data;
    // for(i=0;i<1000;i++);
    while(!TI);
    }
    
    }
    


    please help me to solve this issue. Regards, smitha

Reply
  • Hi,
    i am working on CY7C68013 chip.I am trying to implement SPI using mode0.1Mhz clock is generating,but data is not generating.(CLOCKOUT=24Mhz.I used SM2=0 i.e 24 mhz/12Mhz)I have to get 2 Mhz clock .Below i have attached piece of code which i tried.

    main()
    {
    
    PORTECFG=0x08; //Turn on uart pin rxd0out
    SCON0 = 0x13; //Mode 0, baud 24/12, enable receive,TI=1;RI=1;
    // CKCON &= 0xF8; //Set stretch 0*/
    
    while(1)
    { TI = FALSE;
    SBUF0='B';//spi_Data;
    // for(i=0;i<1000;i++);
    while(!TI);
    }
    
    }
    


    please help me to solve this issue. Regards, smitha

Children