EPM900

Do you have any sample code in assembler

Why not show your code?

Erik

Do you have any sample code in assembler

Why not show your code?

Erik

Here goes this part of the code

MOV P0M1,#10001110B
MOV P0M2,#01110000B
MOV PT0AD,#00000010B
MOV ADMODB,#000H ; This dam thing does not leave
MOV ADINS,#0x010 ; me alone
MOV ADMODA,#0x010

MOV ADCON1,#0x05 ; Go to work

This dam thing does not leave
A language problem, I'm sure, please explain. Are you saying that the uC stop on that instruction?

Erik

When i execute the above lines the SFR's do not assume the new value.

show it all.
some LPC pins can not be modified if bthey are assigned as certain things (e.g. enable IIC and the pins can only be set OC)

also, before selecting analog pins on P1 you should configure P1M1 and P1M2

Erik

I am using port o, as you can see on the code. I use P0.1 as input pin for the A/D to perform a single conversion. I am using the pin to read the battery voltage of the equipment.
Why don't the control registers assume the configuration values?

Why don't the control registers assume the configuration values?
as stated before, the SFRsa will only accept "legal" values.
Have a look at what you set and what you get and check that in the user guide. If that does not clear it up in half an hour, post what you set and what you get.

Erik

The values remain at 0

The values

WHAT values?

Erik

The SFR values. When i perform the mov instruction, the rigister does not assume the new configuration value.

well one step at the time

mov a,#47

if the emulator show acc to be 47, so far, so good

MOV P0M1,#10001110B
mov a,P0M1

what does a show
what does p0m1 show

When i perform the following instructions the ADINS does not assume the new value

MOV A,#0x010
MOV ADINS,A

I am trying to help you, DO WHAT I ASKED, not something else

Erik

Thanks.
That works fine.

What next

Earlier:
Q:the SFRs .....Have a look at what you set and what you get

A:The values remain at 0

Now:
Q:.... MOV P0M1,#10001110B
....what does p0m1 show

A:That works fine.

One is bullshit, which one