• State Not Answered
  • Locked Locked
  • Replies 6 replies
  • Subscribers 21 subscribers
  • Views 2583 views
  • Users 0 members are here
2025 survey

We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.

Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem to use wiggler to do OCDS with infineon XC16Board

Zhilong Ruan

Help! I am having problems getting the OCDS/JTAG connection to work with the infineon XC16Board using the wiggler (parallel port cable)

No matter what I do, I always get the message:
"Error: Flash download failed - Target DLL cancelled"


Anyone could help? Thanks

Parents Reply Children
  • 0 in reply to Zhilong Ruan

    Buy a PCI card with a parallel port?

    - mike

  • 0 in reply to Zhilong Ruan

    "you mean the dongle may affect the connection."

    I am absolutely certain - I have seen it happen! :-(

    If you have a dongle, you must have a full licensed product - so you should speak to Keil support direct about this. You should be able to negotiate a solution.

    Meanwhile, you might like to take a look at the section "Dongle and Parallel Port Communication Issues" in Triscend' FastChip software release note:
    ftp.triscend.com/.../release_note.htm
    Section (2.4) describes a workaround that I found to work for the E5 and dongled PK51 - it may or may not help you with your PK166...

    (Note that I have no affiliation with Keil or Triscend; views expressed are my own)

  • 0 in reply to Andy Neil

    Hi ,

    there is no problem to use OCDS with Infineon Starterboard.
    I tested with Win2k, WinXP and Win98 and a colleaque under WINNT.
    The dongle has no influence (concerning OCDS).
    I test the on-board wiggler and directly with ULINK.
    First you have to check that JP5 is set to enable the onboard wiggler.
    Than you should shut off all other
    parallel port drivers , if there any.
    It costs me approx. 2 days to find out was happen.
    Than you have correct to set the dip switches on board.
    ( Here mainly DIP106 ).
    If your debugger settings in µVision are right so no problems should occur.

    May be that there are problems under XP - there I test only the ULINK.

    Some board was delivered out with unsoldered contacts to JTAG - so check your board concerning this one.

    Stefan