This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Uninstalling Keil completely

Hi all,

I had a project which I could successfully programto my NXP uC using a J-link. When I upgraded my Keil version I could not upload it anymore (erase failed error). I tried downgrading Keil version to 5.12 (which worked previously) and I keep getting the error.

I'm able to program the same project using other computer so the problem should be in some config file. I tried uninstalling it and installing it again deleting all files left in AppData and keil_v5 folders and also the what I could find in Windows key registry and still didn't get it working.

Is there something else I need to remove to completely uninstall it?

Regards,

Mikel

Parents
  • Hi Hans,

    I'm getting an erase fail error. I'm programming an LPC1820 with a J-Link through SWD. I also deleted the J-Link drivers, but I may not did it right because when I plug the J-Link again Windows automatically install it again. I'm using Windows 7.

    Thanks in advance.

    Regards,

    Miguel

Reply
  • Hi Hans,

    I'm getting an erase fail error. I'm programming an LPC1820 with a J-Link through SWD. I also deleted the J-Link drivers, but I may not did it right because when I plug the J-Link again Windows automatically install it again. I'm using Windows 7.

    Thanks in advance.

    Regards,

    Miguel

Children