This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

j-link driver load fail in mdk-arm 5.24

mdk-arm 5.24 link j-link report:
Error:
Cannot load driver 'a:\Keil_v5\ARM\Segger\JL2CM3.dll'.

Possible Reasons: - Driver DLL could not be found in the specified path - Driver DLL requires additional DLL's which are not installed - Required Hardware Drivers are not installed Debugger aborted !

mdk-arm 5.24 preview no this problem

Parents Reply Children
  • With the help of Keil support I isolated the remaining issue.

    I had an old JLink-dll in my path that was used.
    I can control the version of used dll in the debugger dialogue.
    The number 6.14 that was shown was not the one given in Keil directory.

    I removed the old dll from my path (potentially I put a more recent one).

    And no, I am not using China nor EDU Version of JLink :-) I am using JLink Base.

    Regards, Adib.
    --