We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
I am working with the Nordic board PCA10040 using Keil V5.23.0.0. After updating the JLink firmware (requested) Keil stopped allowing breakpoints. I installed latest Segger software 6.30 and it didn't fixed it. I have optimization disabled. What ever I do I can't get back to the state where I had breakpoints. What else could have changed the behavior of Keil?
might try the latest pre version from here http://www2.keil.com/mdk5/525/
Thanks, great job. This fixed it. I have been a little concerned about using a beta version. Our management doesn't like it. So I downloaded 5.24a and it still works.
Greetings, Karl-Heinz