I am working with the Nordic board PCA10040 using Keil V5.23.0.0. After updating the JLink firmware (requested) Keil stopped allowing breakpoints. I installed latest Segger software 6.30 and it didn't fixed it. I have optimization disabled. What ever I do I can't get back to the state where I had breakpoints. What else could have changed the behavior of Keil?
might try the latest pre version from here http://www2.keil.com/mdk5/525/
Thanks, great job. This fixed it. I have been a little concerned about using a beta version. Our management doesn't like it. So I downloaded 5.24a and it still works.
Greetings, Karl-Heinz