We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hi. Using uVisionV4.73 trying to program a cortex M0 device (Quintic SoC) using SW. The device is found in Debug/Settings, but when I try to erase/program I get the error
Cannot Write to RAM for FLash ALgorithms.
Any thoughts?
I do not have VCC connected to the interface; just SWDIO and SWDCLK and gnd. I am using the 10 pin ARM 0.05 connector and the VCC jumper is set to 3.3V
THanks
Pick an SRAM size and address in the Flash dialog which matches the resources available in your SoC
If it continues to fail at addresses that should work, you might want to consult you SoC vendor, and further investigate methods to load and validate the SRAM in the part.