• State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 22 subscribers
  • Views 4040 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Exit debug mode while target is running

Gelika PappRaffy

Hello,
With Keil uvision4 it is possible to exit debug mode / exit Keil, while the target is still running. With uvision5 I can't find a way to do this. Why so? It is a problem for me because in one project I just want to start the debugger so to start the target, and after that I don't need the debugger anymore.
Rgds
Gelika

Parents
  • 0 in reply to ChenTang

    Thanks for the suggestions. I will try the reconnection without reset. And I will kill the process to avoid stopping the target when disconnecting... Hope it will do the trick. The point is that I want to automatise the SW launching, so there is no way to press reset button or to disconnect the cable!

Reply
  • 0 in reply to ChenTang

    Thanks for the suggestions. I will try the reconnection without reset. And I will kill the process to avoid stopping the target when disconnecting... Hope it will do the trick. The point is that I want to automatise the SW launching, so there is no way to press reset button or to disconnect the cable!

Children
No data