S3C2440 spi :how to transfer&recieve continuously

Hello everyone ,I am working with a board based on S3C2440A .

I am trying to transmit datas & commands from S3C2440A to a FRAM_CHIP hang on the S3C2440A' SPI_bus.
I find that S3C2440 only have 8 bit spi_bus_width.
But in fact I need the flow of bits to be continuously at least in a 32 bits.
I know that some chips such as S5PC100 have 8-32 spi_bus_width,how can I make it with S3C2440?

The follow is the code I did,and there was a interval between each flow of 8bit when I observe the SPIMOSI0 & SPICLK signal with oscilloscope.

extern void inline TxSPI0_Byte(U8 data)
{
        rSPTDAT0=data;
        while(!(rSPSTA0&0x01));//wait until Tx/Rx ready
}

extern void WrMemStatReg(unsigned char data) //CMD to operate FRAM
{
        SPICS_LOW;            //FRAM CS ON
        TxSPI0_Byte(WRSR_CMD);//wave A --8bit
        TxSPI0_Byte(data);    //wave B --8bit
        SPICS_HIGH;
}
wave A and wave B are not continuously