hard fault exception

since it is MATLAB generated code ,it should work on its own without much editing from user side....so I have no idea how to do it......
Also I am not able to increase stack size by editing startup_stm32f4xx.s since it is locked
Also code coverage tool option is not active....

also since BFARVALID of Bus Fault status register is high so there is valid bus fault
again IMPRECISERR is high i.e.a data bus error has occurred ,

from "USING CORTEX-M3 AND CORTEX-M4 FAULT EXCEPTIONS" document:
FORCED: Indicates a forced Hard Fault, generated by escalation of a fault with configurable priority that cannot be handled, either because of priority or because it is disabled

FORCED of Hard Fault status register is high means :When this bit is set, the Hard Fault handler must read the other fault status registers to find the cause of the fault.

So may be it is pointing to bus fault.

please help me regarding this

since it is MATLAB generated code ,it should work on its own without much editing from user side....so I have no idea how to do it......
Also I am not able to increase stack size by editing startup_stm32f4xx.s since it is locked
Also code coverage tool option is not active....

also since BFARVALID of Bus Fault status register is high so there is valid bus fault
again IMPRECISERR is high i.e.a data bus error has occurred ,

from "USING CORTEX-M3 AND CORTEX-M4 FAULT EXCEPTIONS" document:
FORCED: Indicates a forced Hard Fault, generated by escalation of a fault with configurable priority that cannot be handled, either because of priority or because it is disabled

FORCED of Hard Fault status register is high means :When this bit is set, the Hard Fault handler must read the other fault status registers to find the cause of the fault.

So may be it is pointing to bus fault.

please help me regarding this

So move a copy of startup_stm32f4xx.s into your project directory, and remove the read-only attribute.

Review the code and processor registers at the fault location.

I am still struck in hard fault exception

after running 36 times(i.e 36 adc conversions & hence 36 outputs at dac) the program is getting into hard fault exception from within this for loop:

 /* Update weights for the next input sample
     */
    j_0 = 0;
    for (j = (int32_T)*startIdx; j < wLen; j++) {
      prodMuErrX = accWtU * xBuf[j];
      prodMuErrX += mul_s32_s32_s32_sr30(leakFac, wBuf[j_0]);
      wBuf[j_0] = prodMuErrX;
      j_0++;
    }

I even checked changing stack size but the number of conversions (i.e 36 ) was independent of change in stack size.

Can somebody please help me regarding this?

Hello Satyajit Sahoo,

maybe Application Note 209 (http://www.keil.com/appnotes/docs/apnt_209.asp) helps you examining the HardFault.

Best Regards, Martin