Hello,
good morning everyone!
I used Keil IDE for a long time with the ulink2 debugger. Going to another plattform for some years i wanted to go back to KEIL. For the new project i tried to install the new MDK-ARM 5.10. Installation seem to be ok, but going to the debugging Settings to the ULINK2 the dialog crashed till i Disconnect the ULINK2. I took a look in the knowlegde Base and found out, that the KeilUL.sys is not installed to the directory C:\windows\system\drivers. Install Drivers run with Admin Privileges. In the Windows Device Manager it is shown as Human Interface Device but not using the KeilUL.sys Library.
Anay Ideas?
Again, the Keilul.sys will not be required or used by ULINK2. This could either be an issue with the driver of your USB Host Controller. Often in this case ULINK2 will not be the only USB device that causes issues on the PC. Or the ULINK2 has a defect. Do you have a chance to test it with a different PC?