Keil forum How to connect Ulink2 to an Infineon XC822?

State Not Answered
Locked Locked
Replies 5 replies
Subscribers 22 subscribers
Views 1017 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to connect Ulink2 to an Infineon XC822?

Peter Müller over 13 years ago

On the XC822 page [1] is said, that the Ulink2 can be used to debug an Infineon XC822.

How to connect the XC822 to the Ulink2? I have found no information about that on the internet.

Thanks Peter

[1] http://www.keil.com/dd/chip/5136.htm

Parents

0 ImPer Westermark over 13 years ago in reply to Peter Müller

Al's link shows a development board with this processor. And there is a link for downloading the support CD for that board. Have you downloaded that CD and checked if there is any schematics for the board?
Cancel
Vote up 0 Vote down

Cancel

Reply

0 ImPer Westermark over 13 years ago in reply to Peter Müller

Al's link shows a development board with this processor. And there is a link for downloading the support CD for that board. Have you downloaded that CD and checked if there is any schematics for the board?
Cancel
Vote up 0 Vote down

Cancel

Children

0 Peter Müller over 13 years ago in reply to ImPer Westermark

@Per
Unfortunately the download link doesn't work.
Cancel
Vote up 0 Vote down

Cancel
0 ImPer Westermark over 13 years ago in reply to Peter Müller

Then you basically have two options.

Use the support link on this forum and ask Keil.

Or use the support link on the Infineon page and ask where to find the linked documentation.
Cancel
Vote up 0 Vote down

Cancel