This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

i wrote in wrong place

hi to all
i want config arm in pwm mode:
1)how programing arm in first program(via I2c or no?)?
2)how write data on eeprom arm for config pwm mode?
hardware:SPK14672
software:c compailer

Parents

0 Andy Neil over 12 years ago in reply to Hui Zhao

Only if it has an I2C interface...
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Andy Neil over 12 years ago in reply to Hui Zhao

Only if it has an I2C interface...
Cancel
Vote up 0 Vote down

Cancel

Children

0 ²erik malund over 12 years ago in reply to Andy Neil

through JTAG only if it has JTAG
through ISP port only if it is an ISP chip
Cancel
Vote up 0 Vote down

Cancel
0 ²erik malund over 12 years ago in reply to Andy Neil

Only if it has an I2C ISP interface
Cancel
Vote up 0 Vote down

Cancel