• State Not Answered
  • Locked Locked
  • Replies 21 replies
  • Subscribers 22 subscribers
  • Views 7107 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Place RW Compression Data

Chris Charleson

is it possible to use a scat file to place the rw compression data?

Parents
  • 0 in reply to @Marc Crandall

    @IB Shy - I read your previous question (linked above) I don't understant what you were trying to do. Did you figure it out?
    Based on your original post (desired layout) I don't see why Roger Ivie answer would not have worked?

    The Load address are where the data lives in the image so you can just use as many load regions as you want to place any and all sections. The execution addresses are were the data gets copied/decompressed to.
    I'm obviously not getting something and would appreciate a clarification even if it's just so I can better understand.

    Thanks.

    M

Reply
  • 0 in reply to @Marc Crandall

    @IB Shy - I read your previous question (linked above) I don't understant what you were trying to do. Did you figure it out?
    Based on your original post (desired layout) I don't see why Roger Ivie answer would not have worked?

    The Load address are where the data lives in the image so you can just use as many load regions as you want to place any and all sections. The execution addresses are were the data gets copied/decompressed to.
    I'm obviously not getting something and would appreciate a clarification even if it's just so I can better understand.

    Thanks.

    M

Children
No data