• State Not Answered
  • Locked Locked
  • Replies 10 replies
  • Subscribers 22 subscribers
  • Views 9131 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem with Flash memory Read Protection

Xavier G

We have a problem with disable a Read Flash protection inside our application with the STM32F103RG.

We arrive in a situtation that the flash memory entire in a Read Protection state because there was a power supply failure. After a power reset, the system is in Flash Read Protection and we would like to disabled this protection without Flash Loader software and without to do an erase mass.

How can we do that ?

Can everybody help us ?

Thanks,

Parents
  • 0 in reply to ²erik malund

    .... the chip is a STM32 and there has been no reports of it going into read protect by a power cycle.

    and we would like to disabled this protection without Flash Loader software and without to do an erase mass

    for which you have no need if you have the source. The likelyhood that you legally should be able to 'suck' the code without having the source is infinitessimally small.

    Erik

Reply
  • 0 in reply to ²erik malund

    .... the chip is a STM32 and there has been no reports of it going into read protect by a power cycle.

    and we would like to disabled this protection without Flash Loader software and without to do an erase mass

    for which you have no need if you have the source. The likelyhood that you legally should be able to 'suck' the code without having the source is infinitessimally small.

    Erik

Children
No data