• State Not Answered
  • Locked Locked
  • Replies 6 replies
  • Subscribers 22 subscribers
  • Views 1517 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

LPC2300.s

sats erty

Hello.
as possible to correct LPC2300.s file, that did my processor go across to necessary address?

Parents Reply Children
  • 0 in reply to sats erty

    I'm sorry, but I do not understand what you are asking/saying.

  • 0 in reply to Non Keil Related

    Have you specified correct addresses for RAM and flash in the project, so that the linker will create a correct application for your specific chip?

    The startup file should normally not need to be changed just to get the application to run.

    It is normally enough to use the configuration wizard (the extra tab you can see if you open the startup file in the IDE) to specify the correct oscillator, and what peripherials that should be powered etc.

    Do you happen to have a processor with external memory, so you need to activate the external memory interface?

  • 0 in reply to ImPer Westermark

    Unfortunantely, the output from your chosen translator is unintelligible.

    :-(

    It is unlikely that any other automatic translator is going to be any better.

    :-(

    If this is a commercial project, you might be better talking to your local distibutor (whether Keil or NXP), or trying to find a local consultant to help you:
    http://www.keil.com/condb

    If it's a school project, you should talk to your tutor and/or confer with your classmates...