This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can't insert breakpoints by button and in C

Hi!

I start to learn STM32 (STM32F103GB on MCBSTM32 board, example project "blinky") and have faced with following problem:
I can't insert breakpoint in C and "insert/remove breakpoint" button on Debug Toolbar always disabled.
The only way to define breakpoint is double-click on grey window bar in disasm window.
Program executed, breakpoint in disasm occurs... but what can I do to use breakpoits in C?

Regards,
Ilya.

Parents

0 Dragi Pandeliev over 15 years ago in reply to Ilya Nikiforov

Are you able to set breakpoints if you debug using Simulator? (In the Debug tab of your project options it is from left)
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Dragi Pandeliev over 15 years ago in reply to Ilya Nikiforov

Are you able to set breakpoints if you debug using Simulator? (In the Debug tab of your project options it is from left)
Cancel
Vote up 0 Vote down

Cancel

Children

0 Ilya Nikiforov over 15 years ago in reply to Dragi Pandeliev

Thank you for your attention! The problem solved.

Regards,
Ilya.
Cancel
Vote up 0 Vote down

Cancel
0 ImPer Westermark over 15 years ago in reply to Ilya Nikiforov

Shouldn't you tell how you solved your problem?
Cancel
Vote up 0 Vote down

Cancel
0 Ilya Nikiforov over 15 years ago in reply to ImPer Westermark

Reinstall Keil and jLink drivers... That's all.
Cancel
Vote up 0 Vote down

Cancel