This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Firmware for EZ-USB FX2LP

I am very new to this subject.
I have a cypress developer board EZ-USB FX2LP.
I just want to connect the board one side to the usb-port and other side the IDE port to HDD.
When I plug the board to PC, the device manager shows EZ-USB FX2LP EEprom missing....
I have the Cypress EZ-USB development kit installed.
What file (HEX,IIC,...) do I have to download to the board, that it works as a USB2IDE bridge?

Parents

0 Stefan Bruder over 14 years ago in reply to Chinzei Tsuneo

Hey Tsuneo,
you made my day,
thank for posting to the right link.
I followed the instructions in the documentation...and I could flash the board and
it renumerated.
I connected a CF card to the IDE adapter, and everything works perfect.

Thank you again...

On the board, there is also a place for ATA/ATAPI connector, do I need to flash with different
iic-file for accessing a HDD (S-ATA drive)?
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Stefan Bruder over 14 years ago in reply to Chinzei Tsuneo

Hey Tsuneo,
you made my day,
thank for posting to the right link.
I followed the instructions in the documentation...and I could flash the board and
it renumerated.
I connected a CF card to the IDE adapter, and everything works perfect.

Thank you again...

On the board, there is also a place for ATA/ATAPI connector, do I need to flash with different
iic-file for accessing a HDD (S-ATA drive)?
Cancel
Vote up 0 Vote down

Cancel

Children

0 Andy Neil over 14 years ago in reply to Stefan Bruder

:-)
Cancel
Vote up 0 Vote down

Cancel