• State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 22 subscribers
  • Views 887 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

7-seg-plugin in uVision in Assembly example

Nisheeth Barthwal

I googled this 7-seg plugin for uVision (drava.etfos.hr/.../7-seg-LEDs_en.htm) & it felt perfect for simulating my asm code without leaving uVision.

But for the love of my life I cannot get the 7-Seg Simulator to work. I doesn't seem to be following the conventional rules.

SETB P0.0
MOV P1, #3FH

does not give 0 on the LED set as

<..SFRPortAddress="0x90" ..>
<commonTerminal SFRPortAddress="0x80" bitPosition="0" activeOn="1" />


and set to activeOn = "1"

The C example given seems to work fine. (If however I remove delay I can't see the changes even while step-debugging)

Any help is greatly appreciated.
Thanks.

Parents
  • 0

    At the end of that page, it clearly says:

    If you have any questions, improvements suggestions, bugs to report ( :-( ), or only to say thanks do not hesitate to contact me via e-mail.

    bboris<insert-at>etfos<insert-dot>hr

    Did you do that?

Reply
  • 0

    At the end of that page, it clearly says:

    If you have any questions, improvements suggestions, bugs to report ( :-( ), or only to say thanks do not hesitate to contact me via e-mail.

    bboris<insert-at>etfos<insert-dot>hr

    Did you do that?

Children