This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to communicate between RS232 VB6.0 & 8051 keil C

I want to have some leds in P2.0~2.3 and show off the "ON" lamp in VB6.0 program though RS232 during the sensors are +5V output to P1.0~1.3 89S52 MCU. But it appears many errors and doesn't work in PC. Please advise me the comments for the following code. Thanks a lot!!

Parents

0 Fong Kwong over 15 years ago in reply to Andy Neil

I always know no shortcut!!
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Fong Kwong over 15 years ago in reply to Andy Neil

I always know no shortcut!!
Cancel
Vote up 0 Vote down

Cancel

Children

0 Fong Kwong over 15 years ago in reply to Fong Kwong

OK! Dont waste my time!!
Cancel
Vote up 0 Vote down

Cancel
0 Andy Neil over 15 years ago in reply to Fong Kwong

Oh, yeah: all those pesky details of learning & understanding what you're doing - what a time-waster!

Good luck with your exams...
Cancel
Vote up 0 Vote down

Cancel
0 Fong Kwong over 15 years ago in reply to Andy Neil

You too~~~
Cancel
Vote up 0 Vote down

Cancel
0 Tamiryan Michael over 15 years ago in reply to Fong Kwong

Hey!! you are not me!!

That pleases me.
Cancel
Vote up 0 Vote down

Cancel