This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XC164CM-16F and uVision3 V3.50b

Hello,

we have bought an XC164CM Easy Kit Board with an XC164CM-16F from Infineon. In uVision3 V3.50b, which is supplied with the CD of Infineon, the device "XC164CM-16F" cannot be found under "Options for Target -> Device", only "XC164CM-8F" and "XC164CM-4F" are listed. Which version of uVison3 should support "XC164CM-16F"?

Thanks in advance
Senmeis

Parents

0 Edward Poore over 14 years ago

Did you get anywhere with your problem? I've just received the same board and been having "fun" getting it to work. Gave up on Seven x64 and now working in an XP virtual machine and at least the drivers appear to be working now.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Edward Poore over 14 years ago

Did you get anywhere with your problem? I've just received the same board and been having "fun" getting it to work. Gave up on Seven x64 and now working in an XP virtual machine and at least the drivers appear to be working now.
Cancel
Vote up 0 Vote down

Cancel

Children

No data