This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

device help

I am intending to use an Atmel AT89LP6440 in a new design. I noticed that this device does not show up in the supported devices list. The chip met the project requirements: non-volatile data memory, plenty of needed I/O pins, SPI/TWI, etc. Any suggestions? Thanks for any help sent!

Parents

0 Andy Neil over 15 years ago in reply to Ruben Govea

You tell it!

See: http://www.keil.com/support/man/docs/uv4/uv4_dg_target51.htm

Also: http://www.keil.com/support/man/docs/uv4/uv4_ca_cpu_ndatabase.htm
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Andy Neil over 15 years ago in reply to Ruben Govea

You tell it!

See: http://www.keil.com/support/man/docs/uv4/uv4_dg_target51.htm

Also: http://www.keil.com/support/man/docs/uv4/uv4_ca_cpu_ndatabase.htm
Cancel
Vote up 0 Vote down

Cancel

Children

0 Ruben Govea over 15 years ago in reply to Andy Neil

Thanks Andy for all your help! Will give a go now.
Cancel
Vote up 0 Vote down

Cancel