hi,
i'm having troubles to connect the keil uVision3 V3.8 to the mcb251. i'm using the following configuration:
IC1 -> AT89C51RE2 IC4 -> empty com1 , 38400 , using 24Mhz crystal RTS: active , DTS: active all cache option is on serial interupt is on
Monitor 51 identification: Not Connected !
jumper setting on MCB251: ext_uart & SRC/D2 & A17 is OFF, all others is ON EA is connected between 1-2
RS232 cable is connected to INT RS232 on MCB251.
please advice nir
hi, i'm not using any converters, direct cable rs232 that worked with atmel eval board.
and about the Application Note 156: http://www.keil.com/appnotes/docs/apnt_156.asp "This application note shows how to modify the Keil MCB251 (MCBx51) Evaluation Board so that you can use the WinISP FLASH programming utility from Atmel Wireless and Microcontrollers."
i'm guessing it means FLIP, i'm using the FLIP 3.3.4