We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
I want run SPI & UART Together....means I initialized UART then SPI... Then I am taking data from SPI and sending through UART on hyper terminal. But I am facing problem to run both modules at time... when I run that modules independent then they are running but when I run it together they gave problem...
If any one have the solution on it Please reply me....
Here, I am using LPC2378 ARM7 Processor...& using SSP0 for SPI... I am also using PLL & I am set PLL Frequency to all peripherals.....
Bla bla bla. Whatever.
The intelect continues to shine.
I am not getting into these exchanges (yet again) thus this is my last message. your personal level so too low for me to even consider to reply - so you are welcome to continue the slander parade, it will teach everybody here a lot more about you than anybody else.