Please note: We are aware of an issue affecting replies on the Arm Community forums, which may not be loading as expected.
We apologize for any inconvenience and appreciate your patience while we investigate and work to resolve the issue.
Thank you for your understanding.
I want run SPI & UART Together....means I initialized UART then SPI... Then I am taking data from SPI and sending through UART on hyper terminal. But I am facing problem to run both modules at time... when I run that modules independent then they are running but when I run it together they gave problem...
If any one have the solution on it Please reply me....
Here, I am using LPC2378 ARM7 Processor...& using SSP0 for SPI... I am also using PLL & I am set PLL Frequency to all peripherals.....
Woohoo. Every line a winner. LOL.
Bla bla bla. Whatever.
The intelect continues to shine.
I am not getting into these exchanges (yet again) thus this is my last message. your personal level so too low for me to even consider to reply - so you are welcome to continue the slander parade, it will teach everybody here a lot more about you than anybody else.