Keil forum Programming UART0/1 on uPSD3354

State Not Answered
Locked Locked
Replies 14 replies
Subscribers 22 subscribers
Views 1839 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Programming UART0/1 on uPSD3354

Stephen Blair over 16 years ago

I cannot seem to get anything out of UART0 or 1 using printf(). What is the correct way to program these UARTS?

Thank you,
Stephen Blair

Parents

0 Stephen Blair over 16 years ago in reply to ²erik malund

I thought this might be it at first too, but the 4 port serial card takes care of the pin swapping.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Stephen Blair over 16 years ago in reply to ²erik malund

I thought this might be it at first too, but the 4 port serial card takes care of the pin swapping.
Cancel
Vote up 0 Vote down

Cancel

Children

No data