We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
I try to debug hello example on beagleboard with DS-5, I got errors as follows,
Connected to gdbserver at file "/home/tang/Project/hello/stripped/hello" WARNING(IMG53): No line debug information in the image hello WARNING(LUX47): The image /home/tang/Project/hello/stripped/hello does not match the target ERROR(LUX48-TAD10-NAL79): ! Failed to set up shared library support ! Failed to read 4 bytes from address 0x0001059C ! Remote GDB returned error code 0x01 add-symbol-file "/home/tang/Project/hello/hello" 0x0 set start-at main start Starting target with image /home/tang/Project/hello/stripped/hello ERROR(TAD8-NAL79): ! Unable to run device 1 ! Failed to enable software breakpoints. Remote GDB returned error code 0x01 quit Successfully disconnected from stopped target gdbserver
But if I copy stripped hello to begaleboard, then run it. It works.
A deeper explanation of these two warnings has been added to the knoweldgebase:
http://www.keil.com/support/docs/3503.htm
http://www.keil.com/support/docs/3490.htm