Hello, I configured a timer to generate a signal every 1 ms.
See below my code about the timer:
TIM_DeInit(TIMx); // TIM1 Deinitialization * TIM_InitStructure.TIM_Mode = TIM_OCM_CHANNEL_1; TIM_InitStructure.TIM_OC1_Modes = TIM_TIMING; TIM_InitStructure.TIM_Clock_Source = TIM_CLK_APB; TIM_InitStructure.TIM_Clock_Edge = TIM_CLK_EDGE_FALLING; TIM_InitStructure.TIM_Prescaler = 0xEF; // period = 5us TIM_InitStructure.TIM_Pulse_Length_1 = 0xC8; // cycle of 200 period => cycle = 1ms TIM_Init (TIMx, &TIM_InitStructure);
And the statements inside timer's interrupt:
void TIM1_IRQHandler(void) { // port 3 pin 7 activated P37_1; // ACK interrupt TIM_ClearFlag(TIM1, TIM_FLAG_OC1); // clear Output Compare 1 flag TIM_CounterCmd(TIM1, TIM_CLEAR); // Reset TIM1 Counter VIC0->VAR = 0xFF; // write any value to VIC0 VAR }
BUT my oscilloscope measured a period of 1.03 ms instead of the 1ms expected. Normally to generate a pulse every 1.03 ms the TIM_Pulse_Length_1 should be set to 0xCE. As you can see, the difference between 0xCE and 0xC8 is big.
What can be the cause of this timer's inaccuracy ? > Problem in PLL configuration ? > Problem of crystal ? > Problem in timer configuration ?
Has someone the same problem ? In advance, thank you
SCU_PLLFactorsConfig(192, 25, 2); /* PLL factors Configuration based on*/ /* a OSC/Crystal value = 25Mhz*/
If this were my project, I'd be seriously worried wether an output frequency of 192 MHz for the PLL might be impossible to achieve with an input of 25 MHz. PLLs like this usually only allow to scale up the input frequency by an integer factor. 192/25 isn't integer.
In the case at hand, I'd expect a result of 8*25 MHz, i.e. 200 MHz. That would throw off all other frequencies and timings by a factor of 200/192, which just so happens to be 1.04. Sound familiar? ;-)