Hello there I am loading an upgrade version of MCU on our MICR check reader with the LPC2000 Flash Utility V2.2.2. This device is connected to serial port (DB9f). I do the steps with the manual I have. In this manual, first I read the Part ID and Boot Loader ID of the device. Then I erase and Blank check. All these parts are done properly but when I want to Upload my HEX file to the flash the Error message is occurred and say "Invalid or Unsupported HEX file!". Can any one help me this problem? Just a little point: In the manual is written the XTAL Freq should be 11059 KHZ and Baud Rate 57600. I use Windows Operating system and change the Baud Rate of COMM port to 57600 but don't know how to change the frequency? Any idea?
There are three major ways of encoding line breaks: - Carriage Return (CR) - Carriage Return + Line Feed (LF) - Line Feed (LF)
Some programs supports all versions. Some one or two. Notepad is known to be stupid. Programmers editors on the other hand can normally handle files from unix, win or mac, and autodetect the line break method - and often convert the line endings.