Hi, I'm using a 8051 MCU which comes with a USB dongle. My question is "How can I configure the USB to be read as a COM port?" Has anyone done it before? All I know is that I need to configure the USB as a Communication Class Device but how do I go about doing it? Any help is very much appreciated.
So why did you choose this chip?
Doesn't sound like this is the application that it's designed for!
Have you explained your requirement to Nordic, and asked if they have something more suitable?
Have you looked elsewhere for something that (more) directly meets your requirements?
Because this chip has been tested to have very low power consumption and has a RF+MCU-in-one chip.
I will be re-writing the firmware myself. Chinzei Tsuneo's links have given been some help. Thank you to everyone else who have contributed with their replies :)
www.8052.com/.../read.phtml
Hi Lionel, have you had any success in porting the CDC code ? I got the Nordic nRF24LU1 SDK/EVKIT a few days ago and was very dissapoined with the S/W support.
I too need to port a CDC Driver .... HID is no good for me.
Richard.