Hi, I'm using a 8051 MCU which comes with a USB dongle. My question is "How can I configure the USB to be read as a COM port?" Has anyone done it before? All I know is that I need to configure the USB as a Communication Class Device but how do I go about doing it? Any help is very much appreciated.
Because this chip has been tested to have very low power consumption and has a RF+MCU-in-one chip.
I will be re-writing the firmware myself. Chinzei Tsuneo's links have given been some help. Thank you to everyone else who have contributed with their replies :)
www.8052.com/.../read.phtml
Hi Lionel, have you had any success in porting the CDC code ? I got the Nordic nRF24LU1 SDK/EVKIT a few days ago and was very dissapoined with the S/W support.
I too need to port a CDC Driver .... HID is no good for me.
Richard.