Hallo,
I've received the error56, that I cannot open my programmed file. I'm using the MCB2300 with LPC2368.
I don't have any Errors or Warnings inside my written Programm and I've done already the following things in the Options: - veryfied under Utilities that I'm using the LPC2000 IAP2 512kB Flash - veryfied under Debug that I'm using the ULINK ARM Debugger with the 200kHz JTAG Clock - veryfied that all other Points in the Options are the same adjustments like every single time before.
I've already erased the Processor with Flash Magic.
My Questions: Is there anything that I'm not noticed already ?? Is it perhaps possible that there's anything in my programm that causes the error ?? Has anyone an idea ??? ( because right now, I don't have any more )
thx
I've found it !
It's not possible to flash the ULINK with a file that's named like I've done.
I've named it USB_2.0 . That wasn't a good idea. Now I've renamed it to USB2 and fortunately it works.
I didn't have a glue that this type of naming isn't possible.
thx ...