This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can't read project project file 'ProjectFileName'!

Hello I am using microVision2 V2.40. When I'm trying to open the project file I have a following get this message
Can't read project project file 'ProjectFileName'!.
Anyone had similar problems?

Top replies

rkopsch over 5 years ago +2 verified

Another idea is that you (today!) are using Windows 8 or 10. These versions are not supported with uVision older than V4.50, see: http://www.keil.com/support/docs/3622.htm
rkopsch over 5 years ago in reply to Andy Neil +1

;-) ...Of course I mean that today(!) he is using Windows 8/10 (I have extended my reply to point this out ) Note, my reply is addressed to today's users of uVision2 that see this forum post and recognize...

Parents

0 rkopsch over 3 years ago in reply to lexa

My recommendation:

- in general (and strongly recommended): Update to Windows 10

- configure 'Unicode' at uVisions Configuration/Editor/General Editor Settings/Encoding
Cancel
Up 0 Down

Cancel

Reply

0 rkopsch over 3 years ago in reply to lexa

My recommendation:

- in general (and strongly recommended): Update to Windows 10

- configure 'Unicode' at uVisions Configuration/Editor/General Editor Settings/Encoding
Cancel
Up 0 Down

Cancel

Children

No data