Is it a good way or important (necessary) to connect the reset pin from the external flash with the reset pin from the microcontroller?
e.g. if you program your external flash via jtag?
Or is it also possible to connect the reset pin to one of the I/O-pins from the microcontroller?
best regards CJendsen
I use this flash memory docs-europe.electrocomponents.com/.../0900766b80a27efb.pdf
with the AT91SAM7A
Maybe someone of you has one suggestion for me - if it is better to connect the reset pin at any I/O pin from the controller or connect this reset pin from the flash with the reset pin from the controller.